4. Open the optional Roller Exchange Kit (KV-SS009), and take out the Paper Feed Roller Module.
5. Install the new Paper Feed Roller Module with the gear on the left side and the bearings into the guide grooves of the side chassis in the
scanner [(1)]. Then push up the levers on both ends until they click into place [(2)].
Note:
Match the Paper Feed Roller Module with the bearings and guide grooves, and then attach it.
6. Push up on the Paper Feed Roller Block and it will magnetically attach to the chassis.
Note:
When attaching the Paper Feed Roller Block to the chassis, do not damage the roller. You are now finished attaching the Paper Feed Roller
Module. To continue, replace the Retard Roller Module according to the following procedure. (The Retard RollerModule is located in the
conveyor).
To Next Page
Loading...
