7. Pull and open the Conveyor(Lower) towards you by using the indent on the right side.
Note:
When the Conveyor is pulled towards you, the rocking mechanism will be release. When opening the Conveyor, be careful not to get your
finger stuck in the indent.
8. Pull the right side of the shaft in the direction of the arrow and hold it there [(1)]. Pull the Retard Roller Module in the direction of the arrow
[(2)] and then remove it.
9. Take out the Retard Roller Module in the optional Roller Exchange Kit (KV-SS009).
10. Pull the right side of the shaft in the direction of the arrow and hold it there [(1)]. Attach the new Retard Roller Module as shown in the
diagram below [(2)] and then return the right side of the shaft in the direction of the arrow [(3)].
Note:
Confirm if pin A and pin B are inserted in their notches correctly. Attach the Retard Roller Module so that the notch A is on the left side.
11. Hold the Conveyor(Lower) using both hands, and close the Conveyor by pushing it into the unit.
To Next Page
Loading...
