Item Parameter Description
Set ICD groups as
DIL destination for
individual CO lines
*1
Yes/No Selecting Yes configures the settings of the ELCOT/
LCOT card and ICD groups as follows:
• The floating extension number
of each ICD group is
assigned sequentially to the DIL destination of each
port of the LCOT card.
→ 12.2 [10-2] DIL Table & Port
Settings—DIL—
DIL Destination—Day,
Lunch, Break, Night
• The first 32 extensions are assigned as members
of every ICD group.
→ 5.13 [3-5-1] Incoming Call Distribution
Group—Group Settings—Member List
• Group
Call
Waiting
Distribution
is enabled for each
ICD group.
→ 5.12 [3-5-1] Incoming Call Distribution
Group—Group Settings—Main—
Call
Waiting Distribution
The effect of these settings is that calls arriving on
different CO lines simultaneously will cause
corresponding S-CO buttons on PTs to light. This
configuration is useful
in situations such as in a general
office. When features such as ICD Group Queuing are
required, such as in a call center, select No.
DHCP Client Enable/Disable Determines whether to use a DHCP server to assign IP
address information automatically or not.
LAN Connection
*2
• IP Address for MPR
Card
• IP Address for
VoIP-DSP
• Subnet Mask
• Default Gateway
Manually enter the LAN information when not using a
DHCP server.
Virtual Card – Select whether to install a V-IPEXT, V-SIPEXT, or
V-SIPGW card.
*1
This setting is displayed only if an ELCOT/LCOT card is already installed when Quick Setup is performed.
*2
If the DHCP Client setting is set to Enable, this parameter can not be set.
Note that the programmable items may vary depending on the version of Maintenance Console being used.
300 Feature Manual Document Version 2013-05
14.1.2 Quick Setup
To Next Page
Loading...
