Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox
(Default)
Switching to VM command +
Recording message command
(#6 + H [H = Mailbox No.])
Recording message command
(H [H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (DTMF commands are not sent. Work with default of the VPS.)
b. Intercept Routing to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a CO line call is
intercepted from an extension to the VPS. Therefore the caller can leave a message for the called
extension without knowing the mailbox number.
[Intercept Routing to the VPS Sequence Selection]
If an extension user
sets Intercept Routing to the VPS, the intercepted CO line calls will be redirected
to the VPS.
It is also possible to send the AA command, even in the VM service mode, when calls are intercepted
so that the caller can be directed to an extension rather than a mailbox. This can be performed by
selecting "AA" through system programming.
® 5.21 [3-8-1] VM(DTMF) Group—System Settings—
Others—Intercept Routing to the VPS
Sequence
Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox Switching to VM command +
Recording message command
(#6 + H [H = Mailbox No.])
Recording message command
(H [H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (Default) (DTMF commands are not sent. Work with default of the VPS.)
Document Version 2013-05 Feature Manual 373
19.1.5 Voice Mail DTMF Integration
To Next Page
Loading...
