16
Making Calls
Auto Talk
The auto talk feature allows you to answer a call by lifting the handset off the base unit without
pressing . The factory preset is OFF. In order to view Caller ID information before answering a
call, leave the auto talk feature OFF.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “
Setting Handset
”, then press
.
3 Press or until the arrow points
to “
Other Option
”, then press .
4 Press or until the arrow points
to “
Auto Talk
”, then press .
•
The current setting is at the arrow.
5
Press or to select
“
ON
”
or
“
OFF
”
.
6 Press .
•
A beep sounds.
•
The display will return to “
Auto Talk
”.
To return to the standby mode, press
or wait for 60 seconds.
•
You can exit the programming mode any time
by pressing .
To store a redial number into
the phonebook
1 Press .
•
The last number dialled is displayed.
2 Press or until the arrow points
to the phone number you desire to store,
then press .
3 Follow steps 4 to 7 on Storing Caller List
Information into Phonebook (p. 23).
4
While
“
Save
” is at the arrow, press
.
•
A beep sounds and “
Saved
” is displayed.
•
The display will return to the stored caller
information.
Storing a Dialled Number into the Phonebook
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
To store an entered number
into the phonebook
1 Enter a phone number.
•
The entered number is displayed.
•
If you misdial, press . Digits are
erased from the right.
•
To cancel, press and hold or press
.
2 Press .
3 Follow steps 4 to 7 on Storing Caller List
Information into Phonebook (p. 23).
4
While
“
Save
” is at the arrow, press
.
•
A beep sounds and “
Saved
” is displayed.
•
The display will return to the entered
phone number.
To Next Page
Loading...
