Panasonic KX-TCD725EM

47
Chapter 3 Programmable Function on the Handset
1 Press .
2 Press or until the arrow points to
“ Setting Handset ”, then press .
3 Press or until the arrow points to
“
Display Option ”, then press .
4 Press or until the arrow points to
“
Talk Display ”, then press .
• The current setting is at the arrow.
“
Talk Time ”: Length of the call
“
Phone No. ”: Dialled phone number
5 Press or to select “ Talk Time ”
or “
Phone No. ”, then press .
• A beep sounds.
• The display will return to “ Talk
Display
”. To return to the standby mode,
press or wait for 60 seconds.
• You can exit the programming mode any time
by pressing .
“ Phone No. ” is selected.
(Ex. 123-456-7890)
Selecting the Talk Mode Display
You can select whether to display the length of the call or the dialled telephone number while in the
talk mode. The factory preset is set to show the length of the call.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
During a conversation, the display will be as
follows.
“ Talk Time ” is selected.
(Ex. 1 hour, 30 minutes, 40 seconds.)
1234567890
01-30-40
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 47