Panasonic KX-TCD725EM

57
Chapter 4
Programmable Function on the Base Unit
4 Press , then select handset
number(s) you desire to ring first.
• The selected handset number(s) blink(s).
Ex. All registered handset number (1 to 6)
is displayed and selected handset
numbers (1 and 5) to ring first blink.
3
Input Command
121 3-123456
5 Press .
• The current number of rings is displayed
at the end of the 2nd line.
6 Select the number of rings 1 through 6
with the dialling buttons to ,
then press .
• A beep sounds.
• The display will return to “ Setting
Base
”. To return to the standby mode,
press .
6
1
Selecting the Selected then All Handsets Ringer
Mode
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “ Setting Base ”, then press .
• “ Input Command ” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 55).
• The current mode is displayed.
1
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 57