Panasonic KX-TCD725EM

Chapter 4
Programmable Function on the Base Unit
63
Reset the Base Unit Settings
1 Press .
2 Press or until the arrow points
to “
Setting Base ”, then press .
• “ Input Command ” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 55).
0
4 Press .
• A beep sounds.
• The display will return to “ Setting
Base
”. To return to the standby mode,
press .
• You can exit the programming mode any time
by pressing .
This function enables the base unit to clear the following settings at one time. They will return to their
initial settings.
Input Command
12------------
Ringer mode selection All handsets
Number of rings
(Selected then all handsets) 3
Earth/Flash Flash
Flash timing 200m seconds
Pause timing 3 seconds
Function
Initial setting
Call restricted All clear
handset(s)
Call restriction All clear
number(s)
4-digit base unit PIN 0000
Base unit ringer volume 2 (MEDIUM)
Total charge for all Clear
handset
Charge rate 00.00
Function
Initial setting
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 63