40
Changing the 4-digit Handset PIN
You can program a 4-digit handset PIN (Personal Identification Number). The factory preset is 0000.
Changing the PIN may prevent the unauthorised use of your unit by another person.
Handset PIN
1 Press .
2 Press or until the arrow points
to “
Setting Handset
”, then press
.
3 Press or until the arrow points
to “
Other Option
”, then press .
4 Press or until the arrow points
to “
Change Hset PIN
”, then press
.
5 Enter the current 4-digit handset PIN.
•
The factory preset is 0000.
6 Enter the new 4-digit handset PIN
TWICE.
•
If you misdial, press . Digits are
erased from the right. To erase all digits,
press and hold .
•
If 5 beeps sound in step 5, the entered 4-digit
handset PIN is incorrect. Enter the correct
PIN.
Once you have programmed the 4-digit Handset PIN, you cannot confirm it. We recommend you to
write down your 4-digit Handset PIN. If you forget it, please consult your nearest Panasonic Service
Centre.
•
A beep sounds.
•
To return to the standby mode, press
or wait for 60 seconds.
1st
2nd
Enter Old PIN
1234567890 :
----
Enter New PIN
1234567890 :
----
Verify New PIN
1234567890 :
----
You need to enter the 4-digit handset PIN for the following functions.
— To set the call prohibition mode ON/OFF (p. 50).
— Reset Handset Settings (p. 53).
— To cancel the base unit (p. 82).
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
4-digit handset PIN
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 40
To Next Page
Loading...
