55
Base Unit PIN
Chapter 4
Programmable Function on the Base Unit
Setting the 4-digit Base Unit PIN
You can program a 4-digit base unit PIN (Personal Identification Number). The factory preset is 0000.
Changing the PIN may prevent the unauthorised use of your unit by another person.
—Cancelling a Handset Registration in the
Base Unit (p. 82)
—Reset the Base Unit Settings (p. 63)
4 Enter the new 4-digit base unit PIN
TWICE.
•
A beep sounds.
•
The display will return to “
Setting
Base
”. To return to the standby mode,
press or wait for 60 seconds.
—Ringer Mode Selection (p. 56, 57)
—Selecting Flash/Earth Mode (p. 59)
—Selecting the Pause Timing (p. 60)
—Call Restriction (p. 61)
1 Press .
2 Press or until the arrow points
to “
Setting Base
”, then press .
•
“
Input Command
” is displayed.
3 Press , then enter the current 4-digit
base unit PIN.
•
The factory preset is 0000.
•
If 5 beeps sound in step 3, the entered 4-digit
base unit PIN is incorrect. Enter the correct 4-
digit base unit PIN.
•
You can exit the programming mode any time
by pressing .
Input Command
5
----
Input Command
5
---- ----
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
Once you have programmed the 4-digit base unit PIN, you cannot confirm it. We recommend you
to write down the 4-digit base unit PIN. If you forget it, please consult your nearest Panasonic
Service Centre.
You need to enter the 4-digit base unit PIN when using the following functions.
4-digit handset PIN
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 55
To Next Page
Loading...
