69
Chapter 5 Answering System
To playback new
incoming/memo message(s)
1 Press
(INT)
then .
2 Press or until the arrow points
to “
Play New Msg
”, then press .
OR
Press
(4)
.
•
New incoming/memo message(s) is/are
played back from the speaker on the
handset if recorded.
•
The unit will announce the remaining
recording time after playback.
•
The display will return to “
Remote
Operation
”. To return to the standby
mode, press or wait for 30 seconds.
To playback all
incoming/memo message(s)
1 Press
(INT)
then .
2 Press or until the arrow points
to “
Play All Msg
”, then press .
OR
Press
(5)
.
•
All incoming/memo message(s) is/are
played back from the speaker on the
handset if recorded.
•
The unit will announce the remaining
recording time after playback.
•
The display will return to “
Remote
Operation
”. To return to the standby
mode, press or wait for 30 seconds.
Incoming/Memo Message
Incoming messages and memo messages are stored in chronological order. New messages cannot be
recorded when “
Memory is Full
” is heard. We recommend you to erase unnecessary message after
each playback in order to leave more time for recording new incoming/memo message(s).
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 During playback an/a incoming/memo
message, press .
2 Press or until the arrow points to
“
Erase One Msg
”, then press .
3 Press or to select “
Yes
”, then
press .
•
One incoming/memo message is erased.
•
The display will return to “
Remote
Operation
”. To return to the standby
mode, press or wait for 30 seconds.
To erase one incoming/memo
message with function menu
1 During playback an/a incoming/memo
message, press .
2 Press then .
•
One incoming/memo message is erased.
•
The display will return to “
Remote
Operation
”. To return to the standby
mode, press or wait for 30
seconds.
To Next Page
Loading...
