Panasonic KX-TCD725EM

Chapter 2 Cordless Telephone
33
Hot Key Dial
The dialling buttons 1 to 9 function as one-touch dials. You can assign up to 9 caller information in the
phonebook into each dialling button 1 to 9 as hot key dial.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
To store a caller information
as hot key dial
1 Follow steps on Finding a Caller
Information in the Phonebook (p. 31),
then press .
2 Press or until “ Reg. To Hot
Key
” is displayed, and press .
• If already stored, “ ” will be displayed on
the left of the hot key number.
3 Press or to select a hot key
number, then press .
4 Press or until “ Save ” is
displayed.
OR
If the hot key number with “ ” is
selected, press or until
“
Overwrite ” is displayed.
5 Press .
• After a few seconds, the display will show
the next caller information.
• To return to the standby mode, press
or wait for 60 seconds.
To make a call with hot key
dial
1 Press and hold a hot key number 1 to 9.
• The stored caller information is displayed.
2 Press or .
• The number is automatically dialled.
3 To hang up, press .
To clear a caller information in
the hot key dial
1 Press and hold a hot key number 1 to 9.
• The stored caller information is displayed.
2 Press .
3 Press or until the arrow points
to “
Clear ”, then press .
• “ Clear ? ” is displayed.
4 Press or to select “ Yes ”, then
press .
• A beep sounds and “ CLEARED ” is
displayed.
• “ No Stored Memory ” is displayed if
clear all hot key dial.
Reg. To Hot Key
H
Key 1
Key 2
KX-TCD725EM-2(24~37) 01.7.19 10:23 PM Page 33