Panasonic KX-TCD725EM

71
Chapter 5 Answering System
1 Press .
• If new message(s) is/are recorded, “ Play
New Msg
” is displayed and pointed by
arrow.
H
Play New Msg
New Phonebook
Setting Handset
During Playback an/a Incoming/Memo Message
To repeat a message
Press to display “ Repeat Msg ”, then
press
.
OR
Press
.
• If you press within 5 seconds from start
playback, the previous message will be played.
• If you press over 5 seconds from start playback,
the current message will be played.
• The display will return to “ Remote
Operation
”. To return to the standby mode,
press or wait for 30 seconds.
1
To skip a message
Press . Press or until the arrow
points to “
Skip Msg ”, then press
.
OR
Press
.
• The next message will be played if recorded.
• The display will return to “ Remote
Operation
”. To return to the standby mode,
press or wait for 30 seconds.
2
During Playback an/a Greeting/Incoming/Memo Message
To stop answering system operation
Press . Press or until the arrow points to “ Stop ”, then press .
OR
Press
.
• The display will return to “ Remote Operation ”. To return to the standby mode, press or
wait for 30 seconds.
9
Quick Play New Message
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
2 Press .
• New message(s) is/are played back.
• The unit will announce the remaining
recording time after playback.
• The display will return to “ Remote
Operation
”. To return to the standby
mode, press or wait for 30
seconds.
KX-TCD725EM-4(65~85) 01.7.19 10:23 PM Page 71