Panasonic KX-TCD725EM

45
Chapter 3 Programmable Function on the Handset
1 Press .
2 Press or until the arrow points
to “
Setting Handset ”, then press
.
3 Press or until the arrow points
to “
Tone Option ”, then press .
4 Press or until the arrow points
to “
Range Alarm ”, then press .
• The current setting is at the arrow.
5 Press or to select “ ON ” or
“
OFF ”.
6 Press .
• A beep sounds.
• The display will return to “ Range
Alarm
”. To return to the standby mode,
press or wait for 60 seconds.
• You can exit the programming mode any time
by pressing .
Setting the Range Warning Alarm ON/OFF
The factory preset is OFF.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
Setting the Battery Low Alarm ON/OFF
The factory preset is ON.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points to
“
Setting Handset ”, then press .
3 Press or until the arrow points to
“
Tone Option ”, then press .
4 Press or until the arrow points to
“
Battery Alarm ”, then press .
• The current setting is at the arrow.
5 Press or to select “ ON ” or
“
OFF ”.
6 Press .
• A beep sounds.
• The display will return to “ Battery
Alarm
”. To return to the standby mode,
press or wait for 60 seconds.
• You can exit the programming mode any time
by pressing .
KX-TCD725EM-3(38~64) 01.7.19 10:42 PM Page 45