General Features
Features Guide 105
The Specification of Trunk Busy-out On
Card Type The status of Trunk Busy-out set to "On" Note
LCOT Idle status
(Default)
Loop OFF
Busy status (the
status of
grabbing a CO
line)
Loop ON
ELCOT Idle status
(Default)
Loop OFF
Busy status (the
status of
grabbing a CO
line)
Loop ON
GCOT Idle status
(Default)
Loop OFF +
Not connected
to Ring FG
Busy status (the
status of
grabbing a CO
line)
Loop OFF +
Connected to
Ring FG
During a
conversation
Loop ON +
Not
connected to
Ring FG
The busy status depends on the Central
Office connected to the PBX.
DID Idle status
(Fixed)
The DID card is a card for only
incoming call. It is assignable for Trunk
Busy-out, but DID call comes in on
even after the setup because the DC
power (On / Off) to the Central Office
from a DID card cannot be controlled.
To Next Page
Loading...
