General Features
Features Guide 277
Flash
Description
The FLASH button is used to allow a PT user to disconnect the current call and originate
another call without hanging up.
Conditions
• Flash or External Feature Access
Pressing the FLASH button on a PT results in either sending Flash signal (External Feature
Access) or disconnecting the current call (Flash). This is determined by System
Programming (Please refer to Programming Guide References below).
• Pressing the FLASH button re-starts the conversation duration, outputs an SMDR record
and checks toll restriction level again.
Programming Guide References
•2.8SystemOption
– FLASH button operation while CO talking
– FLASH button operation when "Don't release the trunk" is selected at #3
• 3.2 Trunk Group
– Disconnecting Time
Features Guide References
1.12 Conversation Features
• External Feature Access
User Manual References
• 4.3.35 External Feature Access
• 4.3.37 Flash
To Next Page
Loading...
