Panasonic KX-TD500 - Page 126

General Features
126 Features Guide
This is determined by System Programming <Section 2.8 System Option, "18. Destination
Busy - DID" in the Programming Guide>.
• The tenant number and VPS trunk group number can be assigned in the DID table so that
the system is shared with tenants on a DID No. basis. It is programmable whether to enable
or disable the tenant assigned on a DID No. basis by System Programming <Section 2.8
System Option, "VM Trunk Service for DID " in the Programming Guide>.
• Tenant number is used to determine the time mode (day / night) for the corresponding DID
number. VPS trunk group number is used in DPT Integration.
Installation Manual References
• 2.5.3 DID Card (KX-T96182)
• 2.5.4 T1 Digital Trunk Card (KX-T96187)
Programming Guide References
• 1.3 Trunk Port Assignment
–GroupNo.
• 1.6 T1 Port Assignment
– Channel Type
–GroupNo.
•2.8SystemOption
– Destination Busy - DID
– Illegal Number - DID
– VM Trunk Service for DID
• 3.2 Trunk Group
– Intercept Destination – Day / Night
•4.2TrunkLine
–GroupNo.
– Incoming Type
– [DID/TIE] Digits to delete
– [DID/TIE] Number to be added
– Digit to receive DID
– Start Signal Type
• 4.3 Extension Line
– Intercept Destination — Day / Night
• 9.2 DID Dial Registration
– DID/MDN No.
–TenantNo.
– VPS Trunk Group No.
– Destination – Day/Night
–Name
Features Guide References
1.3 System Features
• Floating Station