General Features
252 Features Guide
• Floating Station
A Floating Station cannot be programmed as the call forwarding destination.
• Forwarded call is not forwarded furthermore
There can be only one stage of Call Forwarding. If a call is forwarded to an extension in
Call Forwarding mode, the call is not forwarded furthermore.
• Message Waiting notification
A message waiting notification is left on the Call Forwarding setting extension regardless
of a type of Call Forwarding features except for "To CO / TIE Line" and "No Answer to CO
/TIELine."
• Station Hunting
StationHuntingappliestocallsforwardedtoabusyextensioninaStationHuntinggroup.
• An extension user may have only one type of Call Forwarding / Do Not Disturb feature in
effect at any time. If one of Call Forwarding / Do Not Disturb feature is assigned, another
does not function but the assignment itself is preserved for future use. The extension user
can choose either one by pressing the FWD / DND button while on-hook.
In this case, pressing the button changes the settings as follows:
The lighting patterns of the FWD / DND button are as follows:
• Station or User Programming mode
This feature functions even if the extension is in Station/User Programming mode.
• Remote FWD (Call Forwarding) Cancel - Once
The Manager and the Operators can reach an extension that has set Call Forwarding.
• FWD / DND button
Regarding the PT without the FWD / DND button, it can be assigned to a flexible (CO,
DSS, PF) button by Station, User or System Programming.
• Distinctive Dial Tone
When this feature is assigned to the extension, the extension user may hear a distinctive dial
tone (dial tone 2) after going off-hook depending on System Programming <Section 2.8
System Option, "15. Special dial tone after setting feature" in the Programming Guide>.
Intercom calls Extension;
Transfer*
- Items marked with "*" are not available with "Call Forwarding - No Answer to CO /
TIE Line" feature.
Call Type
DND FWD Off
Off : Both functions are canceled.
Red on : DND mode
Red flash : FWD mode
This setting can be changed
by System Programming.
To Next Page
Loading...
