Panasonic KX-TD500 - Page 254

General Features
254 Features Guide
• Treatment of the forwarded call
Toll Restriction, Automatic Route Selection (ARS) and Account Code Entry requirements
of the extension in Call Forwarding mode still apply to the call forwarded by this feature.
• If you are storing an account code, enter the account code and then the delimiter "99" before
thelineaccesscode.
• Extension-to-CO Line Call
If a call between an extension and an outside party is established by this feature, the call
duration can be restricted depending on the setting of the system timer <Section 2.5 System
Timer, "Extension-to-CO Line Call Duration Time" in the Programming Guide>.
• Co-to-CO Line Call
If a call between two outside parties is established by this feature, the call duration is
determined by System Programming <Section 2.5 System Timer, "CO-to-CO Line Call
Duration Time" in the Programming Guide>.
An alarm tone is sent to both outside parties 15 seconds before the time-out.
The call is disconnected at the time-out.
• Trunk-to-Trunk Connection
Before utilizing this feature, "Trunk to Trunk Restriction" should be enabled by System
Programming.
• You can store the telephone number up to 24 digits. Valid digits are "0 through 9," " " and
PAUSE. PAUSE button can also be stored by dialing " ."
• This feature does not apply to the unscreened transfer call.
Programming Guide References
• 2.3 Numbering Plan
– Call FWD - Do Not Disturb Set / Cancel
• 2.4 Class of Service (COS)
– Call FWD to CO/TIE
– Time Limit of Outside Calls
– Trunk Group Setting
– Call FWD Follow Me
•2.5SystemTimer
– Call Forwarding-No Answer Time
– Extension-to-CO Line Call Duration Time
– CO-to-CO Line Call Duration Time
• 2.7TrunktoTrunkRestriction
•2.8SystemOption
– Special dial tone after setting feature
– FWD / DND lamp pattern
• 4.3 Extension Line
–COKey
–PFKey
– Call Forwarding-No Answer Time
• 4.4 DSS Console
–DSSKey
–PFKey