EasyManua.ls Logo

Panasonic KX-TD500 - Page 259

Panasonic KX-TD500
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Features
Features Guide 259
Hold Recall tone:
Hold Recall tone is generated to the extension who transferred the call 50 seconds before
the time-out.
Hold Alarm tone:
Hold Alarm tone is generated to both outside parties 15 seconds before the time-out. The
call is disconnected at the time-out unless the extension user (who transferred the call) joins
the CO-to-CO call to establish a conference call.
CO-to-TIE call
If a CO call is transferred to the destination party via TIE line, a CO-to-TIE call is
established and the call duration is restricted depending on the setting of the system timer.
<Section2.5 System Timer, "CO-to-CO Line Call Duration Time" in the Programming
Guide>
[Unscreened - to Extension]
Transfer Recall Destination
If the call (either extension or outside) transferred to the destination party is not answered
within a specified period of time <Section 2.5 System Timer, "Transfer Recall Time" in the
Programming Guide>, it may ring an Operator Group extension instead of the extension
who originally transferred it. This is determined by System Programming <Section 2.8
System Option, "6. Transfer recall destination" in the Programming Guide>.
Automatic Disconnection
If there is no answer for 30 minutes after "Transfer Recall" starts, the line will be
disconnected.
Camp-on Transfer
When the transfer destination party is busy, the call is put in waiting status. If the destination
party remains busy or does not answer the call within a specified period of time <Section
2.5 System Timer, "Transfer Recall Time" in the Programming Guide>, the call will ring
back the extension who transferred the call or an Operator extension.
Ringing Pattern
A transferred call will ring following the regular ringing pattern depending on the type of
call (extension or outside) being transferred.
Remote Administration
Any extension user can transfer a call to the Remote resource (Modem) for Remote
Administration.
A CO call can be transferred directly to a Uniform Call Distribution (UCD) group so that
an idle extension is automatically hunted by UCD. If all extensions in a UCD group are
busy, the incoming CO call will be handled by the UCD Time Table.
During a call transfer to the Remote Resource (Modem), a confirmation tone is not emitted
after dialing the FDN for the Remote Resource.

Table of Contents

Other manuals for Panasonic KX-TD500

Related product manuals