Panasonic KX-TD500 - Page 386

TIE Line Features
386 Features Guide
Conditions
• Basic Programming
The Programming items listed in the following "Programming Guide References" are
always required to make use of TIE lines.
• Application Programming
Programming items required vary depending on a type of applications. Please refer to the
following features in this section for further information about each application
programming.
– Outside (CO) Line and TIE Line Connection
– TIE Line and Outside (CO) Line Connection
– TIE Line and TIE Line Connection
– TIE Line Network – Alternate Routing
Installation Manual References
• 2.5.4 T1 Digital Trunk Card (KX-T96187)
• 2.5.7 PRI23 Card (KX-TD50290)
Programming Guide References
• 1.2 Slot Assignment
• 1.6 T1 Port Assignment
– Channel Type
–GroupNo.
• 1.9 PRI Port Assignment
–Type
–GroupNo.
• 2.3 Numbering Plan
– TIE Line Access
– Other PBX 01 - Other PBX 16
•2.5SystemTimer
– TIE Inter-digit Time
•4.2TrunkLine
–GroupNo.
– Incoming Type
– [DID/TIE] Digits to delete
– [DID/TIE] Number to be added
– Start Signal Type
• 4.3 Extension Line
– [CLIP Number] Public
– [CLIP Number] Private
• 4.7 ISDN Extension Line
– [CLIP Number] Public
– [CLIP Number] Private