Panasonic KX-TDA100

To change the status (INS/OUS) of a card (Interactive mode only)
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select the desired status:
• Click INS to set the card to in-service status.
• Click OUS to set the card to out-of-service status.
To install an option card on an OPB3 card
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select Option Card.
The OPB3 Option Card Setup screen will be displayed. See 3.43 [1-1] Slot—OPB3 Option Card
Setup (KX-TDA100/KX-TDA200
/KX-TDA600 only)
.
Supported Card Types
KX-TDA30
Card
Maximum
Quantity
Supported Slot
Numbers
Card Programming
MPR: Main Processing Card 1 00 3.3 [1-1] Slot—Card Property - MPR
DHLC4: Pre-installed Super Hybrid
Ports
1 01
3.4 [1-1] Slot—Card Property -
Extension Type
DLC4: 4-Port Digital Extension Card
1
02–04 (Type A
Slots)
SLC4: 4-Port Single Line Telephone
Extension Card
BRI1: 1-Port BRI Card
3
3.13 [1-1] Slot—Card Property - BRI
type/PRI type
BRI2: 2-Port BRI Card
LCOT2:
2-Port Analogue Trunk Card
3.10
[1-1] Slot—Card Property
- LCO
type
LCOT4: 4-Port Analogue Trunk Card
DID3: 3-Port DID Card 3.30 [1-1] Slot—Card Property - DID
type
DLC8: 8-Port Digital Extension Card
2
05–07 (Type B
Slots)
3.4 [1-1] Slot—Card Property -
Extension Type
SLC8: 8-Port Single Line Telephone
Extension Card
E1: E-1 Trunk Card 1 3.21 [1-1] Slot—Card Property - E1
type
IP-GW4: 4-Channel VoIP Gateway
Card
1 3.33 [1-1] Slot—Card Property - IP
Gateway
IP-EXT4: 4-Channel VoIP Extension
Card
1 3.36 [1-1] Slot—Card Property - IP
Extension
SIP-GW4: 4-Channel SIP Trunk
Card
1 3.39 [1-1] Slot—Card Property - SIP
Gateway (KX-TDA30 only)
PC Programming Manual 101
3.1 [1-1] Slot