Panasonic KX-TDA100

2.2 Start Menu
2.2.1 Start Menu—New
Creates a new system data file, used to programme the PBX in Batch mode. All settings are in their initial or
default state.
This option is only available at Installer level.
To upload
the file created here to the SD memory card installed in the PBX, see 2.6.2 Utility—File Transfer
PC to PBX (SD Card).
Note
Since selecting
this option creates a blank system data file, uploading this file to the PBX will overwrite all
previous settings. Use only when necessary.
To create a new system data file
1. From the start menu, select New.
2. Click the appropriate model number.
3. Select whether an EMEC (KX-TDA600) or MEC (KX-TDA30/KX-TDA100/KX-TDA200) card is installed or
not.
4. Click OK.
PC Programming Manual 35
2.2.1 Start Menu—New