Panasonic KX-TDA100

2.6 Utility
2.6.1 Utility—Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can be
saved as a TXT-format (text) file.
When testing
is complete, any cards that were set to OUS status must be returned to INS status if they are to
be used again.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according
to the type of card being tested.
The tests that are performed on each card are as follows:
KX-TDA30
Test Type Available Cards
Local loop back diagnosis DHLC4, DLC8, SLC4, SLC8, IP-EXT4, LCOT, DID3, BRI, IP-GW4,
SIP-GW4, E1
Card CT Bus diagnosis DLC8, SLC8, IP-EXT4, IP-GW4, SIP-GW4, E1
DTMF Receive test port DHLC4, SLC4, SLC8
MSG/SVM Card DTMF receive test MSG2, SVM2, ESVM2
EXT-CID path test EXT-CID
DSP DTMF generator/receiver
diagnosis
E1
DSP DTMF receiver diagnosis E1
Framer IC alarm signal detection
diagnosis
E1
Framer IC error detection diagnosis E1
KX-TDA100/KX-TDA200/KX-TDA600
Test Type Available Cards
Local loop back diagnosis DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,
ECSLC24, CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB, E&M, DID,
IP-EXT16
Card CT Bus diagnosis (
KX-TDA100/
KX-TDA200 only)
DHLC, DLC, SLC8, SLC16
, MSLC16, ESLC16, EMSLC16, CSLC16,
CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB, E&M, DID, IP-EXT16
DTMF Receive test port DHLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,
ECSLC24, E&M, DID
PT loop back diagnosis DHLC, DLC
PC Programming Manual 61
2.6.1 Utility—Diagnosis