Panasonic KX-TDA100

2.2.5 Operator Features
ARS Mode
Specifies the ARS mode used when making a trunk call.
Value Range
Off: ARS is disabled.
On for
Local Access Operation: ARS operates when an extension user makes a call using any Idle Line Access
method.
On for Any CO Access Operation: ARS operates when an extension user makes a call using any Trunk Access
method.
Same as System Setting: The setting specified in
ARS Mode in 10.1 [8-1] System Setting is applied
Maintenance Console Location
8.6 [6-6] Tenant
Programming Manual References
10.1 [8-1] System Setting
Feature Guide References
1.10.1 Automatic Route Selection (ARS)
2.2.3 Tenant Service
System Speed Dial
Specifies which system speed dialling table is used by the tenant. This setting is only available when an
MEC (KX-TDA30/KX-TDA100/KX-TDA200) or EMEC (KX-TDA600) card is installed.
Value Range
For KX-TDA30:
Basic Memory: PBX basic system speed dialling numbers are used.
Expanded Memory: Expansion system speed dialling numbers are used.
For KX-TDA100/KX-TDA200/KX-TDA600:
Same as System Setting: PBX common system speed dialling numbers are used.
Tenant Exclusive: Individual tenant system speed dialling numbers are used.
Maintenance Console Location
8.6 [6-6] Tenant
Programming Manual References
8.1 [6-1] System Speed Dial
Feature Guide References
1.6.1.5 Speed Dialling—Personal/System
PC Programming Manual 773
8.6 [6-6] Tenant