6.11 [4-2-1] Portable Station—Extension Settings—
CLIP Generate
CLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together.
Pre-assigned CLIP numbers for those locations will be overwritten.
If a number generated here is longer than 16 digits, the additional digits will be discarded.
Location Entry—Beginning Entry Location (Ext. Number)
Specifies the extension number of the first location to be programmed.
Value Range
PS extension number
Maintenance Console Location
6.11 [4-2-1] Portable Station—Extension Settings
—CLIP Generate
Programming Manual References
6.10 [4-2-1] Portable Station—Extension Settings
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
Location Entry—Number to Generate
Specifies the number of locations to be programmed.
A CLIP number will only be assigned to registered PS extensions, even if the number entered here is larger
than the total number of PS extensions.
Value Range
1–total number of connected wired extensions
Maintenance Console Location
6.11 [4-2-1] Portable Station—Extension Settings—CLIP Generate
Programming Manual References
6.10 [4-2-1] Portable Station—Extension Settings
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
Parameter—Deleting Digits
Specifies the
number of digits to be deleted from the start of an extension number when using it as part of the
CLIP number.
PC Programming Manual 681
6.11 [4-2-1] Portable Station—Extension Settings—CLIP Generate
To Next Page
Loading...
