Panasonic KX-TDA100 - Page 108

Maintenance Console Location
3.2 [1-1] Slot—Summary
Programming Manual References
3.1 [1-1] Slot
3.4 [1-1] Slot—Card Property - Extension Type
3.10 [1-1] Slot—Card Property - LCO type
3.13 [1-1] Slot—Card Property - BRI type/PRI type
3.18 [1-1] Slot—Card Property - T1 type (KX-TDA100/KX-TDA200/KX-TDA600 only)
3.21 [1-1] Slot—Card Property - E1 type
3.27 [1-1] Slot—Card Property - EM type (KX-TDA100/KX-TDA200/KX-TDA600
only)
3.30 [1-1] Slot—Card Property - DID type
3.33 [1-1] Slot—Card Property - IP Gateway
3.36 [1-1] Slot—Card Property - IP Extension
3.39 [1-1] Slot—Card Property - SIP Gateway (KX-TDA30 only)
3.41 [1-1] Slot—OPB3 Card Property (KX-TDA100/KX-TDA200/KX-TDA600
only)
3.44 [1-1] Slot—Card Property - CTILINK (KX-TDA100/KX-TDA200/KX-TDA600 only)
3.45 [1-1] Slot—Card Property - DPH type (KX-TDA30 only)
3.47 [1-1] Slot—Card Property - ESVM Type (KX-TDA30 only)
Feature Guide References
None
Status
Indicates the card status (reference only)
Note that MPR card status is always displayed as "-".
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Pre-Install: A card has been added to the slot.
Idle: No card is installed in the slot.
Maintenance Console Location
3.2 [1-1] Slot—Summary
Programming Manual References
3.1 [1-1] Slot
Feature Guide References
None
Version
Indicates the LPR version of the installed card (reference only).
108 PC Programming Manual
3.2 [1-1] Slot—Summary