Panasonic KX-TDA100

Feature Guide References
1.24.1 Voice Mail (VM) Group
1.32.1 Computer Telephony Integration (CTI)
DPT Type—Location No.
Specifies the location number of the connected DSS Console or PC Console. This setting is only available
when DPT Type—Type on this screen is set to DSS or PC Console.
Note that,
depending on system traffic, there may be a limit to the number of PC Consoles that can be supported
by a single DLC/DHLC card.
When changing the location number of a DSS Console for which one or more SDN buttons are set, all SDN
buttons customised for that device will be deleted. When you attempt to apply the new settings, a warning
message is displayed showing the slot and port number for which SDN buttons will be deleted. If you do not
wish to delete SDN buttons for this port, click Cancel.
Value Range
For KX-TDA30:
Location number for DSS Console: 1–4
Location number for PC Console: 1, 2
For KX-TDA100/KX-TDA200:
1–8
For KX-TDA600:
Location number for DSS Console: 1–64
Location number for PC Console: 1–8
Maintenance Console Location
3.5 [1-1] Slot—Port Property - Extension Port
Programming Manual References
None
Feature Guide References
1.32.1 Computer Telephony Integration (CTI)
DPT Type—VM Unit No.
Selects the unit number of the connected VPS. This setting is only available when DPT Type—Type on
this screen is set to VM (DPT).
Value Range
For KX-TDA30:
1
For KX-TDA100/KX-TDA200
:
1, 2
PC Programming Manual 123
3.5 [1-1] Slot—Port Property - Extension Port