Programming Manual References
None
Feature Guide References
1.21.1.1 Integrated Services Digital Network (ISDN)
—SUMMARY
BRI Data Link (P-MP) Mode
Assigns one
or two TEIs (Terminal Endpoint Identifier) to the BRI CO port. To use the ISDN Hold supplementary
service with point-to-multipoint configuration, this parameter should be set to 2-link in some countries/areas.
Value Range
1-link: One TEI is assigned to the BRI CO port.
2-link: Two TEIs are assigned to the BRI CO port. (Available when
Access Mode on the Network tab is
set to P-MP.)
Maintenance Console Location
3.14 [1-1] Slot—Port Property - BRI Port
Programming Manual References
None
Feature Guide References
None
Networking Data Transfer
Enables transmission of extension status data to connected PBXs in a network. This setting is only available
when Port Type on this screen has been set to QSIG-Slave or QSIG-Master.
A maximum of two ports of each BRI card can be assigned to transmit extension status information.
Value Range
No, Yes
Maintenance Console Location
3.14 [1-1] Slot—Port Property - BRI Port
Programming Manual References
Section 11 [9] Private Network
Feature Guide References
1.30.5.1 Network Direct Station Selection (NDSS)
174 PC Programming Manual
3.14 [1-1] Slot—Port Property - BRI Port
To Next Page
Loading...
