Panasonic KX-TDA100 - Page 300

Programming Manual References
None
Feature Guide References
None
Line Signal Setting—Wink Signal Width
Specifies the length of a wink signal.
Value Range
32 ´ n (n=4–9) ms
Maintenance Console Location
3.30 [1-1] Slot—Card Property - DID type
Programming Manual References
None
Feature Guide References
None
Caller ID—Caller ID Start Code
Selects the DTMF code used to detect the beginning of a Caller ID series.
Value Range
*, #, A–D
Maintenance Console Location
3.30 [1-1] Slot—Card Property - DID type
Programming Manual References
None
Feature Guide References
1.18.1 Caller ID
Caller ID—Caller ID Information End Code
Selects the delimiter used to separate multiple parameters in a Caller ID series.
Value Range
*, #, A–D
300 PC Programming Manual
3.30 [1-1] Slot—Card Property - DID type