Panasonic KX-TDA100 - Page 814

Tenant Number
Specifies the
tenant number, to determine the Time Table by which calls are distributed depending on the time
of day.
Value Range
For KX-TDA30/KX-TDA100/KX-TDA200:
1–8
For KX-TDA600:
1–32
Maintenance Console Location
12.2 [10-2] DIL Table & Port Settings
Programming Manual References
None
Feature Guide References
1.1.1.2 Direct In Line (DIL)
2.2.3 Tenant Service
2.2.4 Time Service
VM Trunk Group No.
Specifies
the
number of the VM trunk group sent to the VPS when the DIL destination is the floating extension
number of a VM (DPT) Group.
The VM trunk group number is used to allow the VPS to send the applicable greeting message to the caller.
Value Range
1–48
Maintenance Console Location
12.2 [10-2] DIL Table & Port Settings
Programming Manual References
None
Feature Guide References
1.1.1.2 Direct In Line (DIL)
1.24.3 Voice Mail DPT (Digital) Integration
CLI for DIL
When CLI distribution is enabled for a trunk to which DIL distribution is set, incoming trunk calls will be
distributed to the CLI destinations (instead of the DIL destinations) if the caller’s identification number is found
in the System Speed Dialling Table.
814 PC Programming Manual
12.2 [10-2] DIL Table & Port Settings