2. Fasten the wall mounting adaptor to the base with 1 screw. (Recommended torque: 0.4 N·m [4.08 kgf·cm/
3.54 lbf·in] to 0.6 N·m [6.12 kgf·cm/5.31 lbf·in])
3. Connect the cables to the unit, and run the cables through the wall mounting adaptor, as shown in the
illustration below.
For details about connecting the cables, see "Connections (Page 62)".
Note
• The cables can also be run from the bottom of the unit.
40 mm (1
37
/
64
in)
or less
Ethernet cables
AC adaptor
66 Operating Instructions Document Version 2014-11
Installation and Setup
To Next Page
Loading...
