Base Unit Settings
For assistance, please visit http://www.panasonic.com/phonehelp 153
Setting UPnP to display the shortcut
To display the KX-WPA102 shortcut in the My Network Places folder, Windows component
should be added. Enable UPnP (Universal Plug and Play) following the steps below.
1 Click [Start], then click [Control Panel].
2 Click [Add or Remove Programs], then click [Add or Remove Windows
Components].
3 Select [Network Service], then click [Details…].
4 Check [Universal Plug and Play], then click [OK].
5 Click [Next>].
Note:
L If you are using Windows XP Service Pack 2, check [Internet Gateway Device
Discovery and Control Client] and [UPnP User Interface] in step 4.
Using your computer on a wireless LAN
The 15 character device-specific Network name (SSID), 13 alphanumeric character 128
bit encryption Network key (WEP) and 16 alphanumeric character Network key (WPA-
PSK/WPA2-PSK) are set as factory default. These factory default setting values are
displayed on the included WLAN sticker. If you use your computer on a wireless LAN, use
the values on the sticker to set the wireless LAN configuration of your computer. To set
your computer to be used on a wireless LAN, see the manual for the computer you use.
Note:
L To use your computer on a wireless LAN, a wireless LAN card needs to be installed on
your computer.
To Next Page
Loading...
