Getting Started
32 For assistance, please visit http://www.panasonic.com/phonehelp
5 Select the desired connection type used in HOME mode, then click [Next>].
L Internet connection modes vary according to the Internet service provider. Select a
connection mode referring to the Internet service provider’s setup information.
L Select [PPPoE], [DHCP] or [Static] if the base unit is installed in Router mode.
Select [AP (Bridge)] if the base unit is installed in AP (Bridge) mode.
L A screen with fields for configuring the connection type you select in this step is
displayed. See “Configuring the Internet connection settings” on page 36.
Setting Description
[PPPoE] L This connection mode is usually required for use with DSL
modems.
[DHCP] L Allows the base unit to receive an IP address automatically
from a DHCP server. This connection mode is usually
required for use with cable modems.
[Static] L Allows the base unit to assign a specific IP address.
[AP (Bridge)] L Allows the base unit to work as an access point when you
have a router at home. ([AP (Bridge)] is not available in
HOTEL mode.)
To Next Page
Loading...
