The status condition when sensing object ‘C’ is present
that has the greatest intensity of incident light.
Press the
Jog switch.
Incident light
intensity for P-3.
Upper limit value 2_SL
Lower limit value 1_SL
Upper and lower limits have
not been correctly set.
The symbol ‘
’ will be
displayed repeatedly.
Press the
MODE key 5 times.
7If the [Jog switch] is pressed while in the status condition
when sensing object ‘C’ is present that has the greatest
intensity of incident light, the display will blink the incident
light intensity reading (red).
8The display will indicate whether the upper and lower limits
have been correctly set and the setting for ‘lower limit value
1_SL’ (green) will be displayed.
• If ‘ ’ (red) is blinking…the upper and lower limits have
been set correctly.
• If ‘ ’ (red) is blinking…the upper and lower limits have
not been set correctly.
9Then the setting for ‘upper limit value 2_SL’ (green) will be
displayed.
0By pressing the [MODE key] 5 times, the amplifier will return
to ‘RUN mode’ (normal sensing operation).
‘Lower limit value 1_SL’ (green) and incident light intensity
(red) will be displayed.
To Next Page
Loading...
