7-3. Data Bank Save Function
This function saves amplifier settings.
Up to 3 sets of settings can be saved using ‘ ’ ‘ ’ and ‘ ’ .
You can select whether the settings for only one amplifier are saved or the settings for all amplifiers on the right
side that are connected via optical communication are saved all in a single step.
The digital display
will scroll twice.
The digital display will blink
to confirm the setting.
Press the
MODE key 5 times.
Turn the Jog switch 3 times
toward the ‘
Ⳮ’ direction.
Turn the Jog switch once
toward the ‘Ⳮ’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Press the
MODE key
once.
Press the
MODE key
once.
Turn the Jog switch to select the
desired channel for saving.
* When saving only the
following one amplifier
* When saving all amplifiers
in a single step
Saving all amplifiers
in a single step
Saving one
amplifier only
Turn the Jog switch to select whether to save
settings for one amplifier or all amplifiers
in a single step.
The digital
display will
blink to
confirm
the setting.
Channel 1 Channel 3Channel 2
1Press the [MODE key] 5 times to select ‘PRO mode’.
9
If the [Jog switch] is pressed, the letters ‘ ’ (red) will blink.
2Turn the [Jog switch] 3 times toward the ‘Ⳮ’ direction, to
select ‘PRO3 mode’.
3Press the [Jog switch] to enter the ‘data bank load setting’
state.
4Turn the [Jog switch] once toward the ‘Ⳮ’ direction, to enter
the ‘data bank save setting’ state.
5If the [Jog switch] is pressed, the current setting will be
displayed.
6Turn the [Jog switch] to select whether to save settings for
one amplifier or all amplifiers in a single step.
7If the [Jog switch] is pressed, the selected setting will be
confirmed.
8If the [Jog switch] is turned, the ‘channel’ will be changed.
Select the desired ‘channel’ for saving.
AIf the [MODE key] is pressed once, the amplifier will return to
‘PRO3 mode’.
0
If the [Jog switch] is pressed while ‘ ’ (red) is blinking, the
settings will be saved to the selected ‘channel’.
‘ ’ (red) will quickly blink, and ‘ ’ (red) will blink to
confirm the new setting.
If saving settings for all amplifiers in a single step, the display
will scroll twice and then the channels being saved will blink
(red) and the settings will be confirmed.
BPress the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
To Next Page
Loading...
