Be sure to set each item after selecting output 1 or output 2.
The items that can be set in output 1 and output 2 respectively are only 1 Threshold value, 2 Output
operation, 3 Timer operation and Timer period, and 4 Sensing mode (Output 2 can only be selected in
normal mode). The items other than those are common. (However, in case of setting with the direct code, a
combination of the output 1 / 2 can be set only for output operation. The items other than output operation are
valid only for the output 1.)
To cancel any operation, press the [MODE key]. If the [MODE key] is pressed once, the amplifier will return to
the previous settings status, immediately before the [Jog switch] was pressed and the selected setting has
been confirmed.
Others
3
Press the MODE
key once.
Example: When operating in PRO mode.
Press the Jog
switch once.
When changing the status of any setting, ensure that the selected setting is subsequently confirmed.
If confirmation is not performed, the new setting will not take effect.
Canceling operations
3-1. Precautions When Selecting Settings
Confirming settings
1Select ‘PRO mode’.
1Select ‘response time change’.
2If the [Jog switch] is pressed, the current mode (red) will be
displayed.
* The factory setting is ‘STD (standard)’.
3If the [Jog switch ] is turned, the digital display (red) will blink.
Select the desired mode.
3To cancel the ‘response time change’ operation, press the
[MODE key] once.
4
The display will return to the previous [PRO1 mode] selection
screen.
H-SP
(ultra high-speed)
Example: When setting response time change.
FAST
(high-speed)
Press the Jog switch.
Press the Jog switch.
The digital display will quickly blink to confirm the setting.
STD (standard) U-LG
(ultra long-range)
Select the desired mode
by turning the Jog switch.
To cancel
2If the [Jog switch] is pressed once, the amplifier enter the
‘response time change’ state.
[ move left side (Green)]
4If the [Jog switch] is pressed, the digital display (red) will
quickly blink, confirming the setting.
The digital display will not blink if the setting has not been
changed.
()
3
To Next Page
Loading...
