Panasonic LS-400 Series - CUSTOM Mode Display Function

9-5. CUSTOM Mode Display Function
Press the
MODE key 5 times.
Turn the Jog switch 5 times
toward the ‘
Ⳮ’ direction.
Turn the Jog switch 3 times
toward the ‘Ⳮ’ direction.
Press the
Jog switch.
Press the
Jog switch.
Code settingData bank
load
Emission haltM.G.S.Response time
change
Press the
Jog switch.
Press the
MODE key once.
Press the
MODE key once.
Select function
by turning the Jog switch.
This selects one function that you would like to display in the navigation display in CUSTOM mode.
1Press the [MODE key] 5 times to select ‘PRO mode’.
3Press the [Jog switch] to enter the ‘code setting’ state.
7If the [Jog switch] is pressed, the setting will be confirmed.
2Turn the [Jog switch] 5 times toward the ‘Ⳮ’ direction, to
select ‘PRO5 mode’.
4Turn the [Jog switch] 3 times toward the ‘Ⳮ’ direction, to
enter the ‘CUSTOM mode display selection’ state.
8If the [MODE key] is pressed once, the amplifier will return to
‘PRO5 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
5If the [Jog switch] is pressed, the current CUSTOM mode
setting (red) will be displayed.
* The factory setting is ‘Response time change’.
6If the [Jog switch] is turned, the CUSTOM mode (red) will
blink on the digital display.
Select the desired function to display in CUSTOM mode.
51
Ramco National
(800) 280-6933
www.panasonicsensors.com