6-4. ECO Mode Function
This function turns off the digital display to reduce power consumption.
If no operations are performed for 20 sec., the letters ‘ ’ (green) will blink and then the digital display will turn off.
If the [MODE key] or the [Jog switch] are operated, the digital display will light up again.
Only when
ECO ON
ECO
OFF
ECO
ON
When set to ECO OFF When set to ECO ON
When ECO mode is OFF:
40 mA or less (at 24 V supply voltage)
When ECO mode is ON:
33 mA or less (at 24 V supply voltage)
Current Consumption
Press the
MODE key 5 times.
Turn the Jog switch twice
toward the ‘
Ⳮ’ direction.
Turn the Jog switch twice
toward the ‘
Ⳮ’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Press the
MODE key once.
Press the
MODE key once.
The digital display will quickly
blink to confirm the setting.
No operation has been
performed for 20 sec.
Operating either the
MODE key or the Jog
switch causes the
display to light up
again.
Select between ECO ON / ECO OFF
by turning the Jog switch.
1Press the [MODE key] 5 times to select ‘PRO mode’.
3Press the [Jog switch] to enter the ‘display switching’ state.
2Turn the [Jog switch] twice toward the ‘Ⳮ’ direction, to
select ‘PRO2 mode’.
8If the [MODE key] is pressed once, the amplifier will return to
‘PRO2 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
4Turn the [Jog switch] twice toward the ‘Ⳮ’ direction, to enter
the ‘ECO mode setting’ state.
5If the [Jog switch] is pressed, the current ‘ECO mode setting’
(red) will be displayed.
* The factory setting is ‘ECO OFF’.
6If the [Jog switch] is turned, ‘ECO mode setting’ (red) will
blink on the digital display.
Select from either ‘ECO ON’ or ‘ECO OFF’.
0Only when the amplifier is set to ECO ON and no operations
are performed for 20 sec., will the letters ‘ ’ (green) blink
and the digital display then turn off.
AIf the [MODE key] or the [Jog switch] are operated, the
digital display will light up again.
To return the amplifier to the original state, select the setting
ECO OFF.
7If the [Jog switch] is pressed, ‘ECO mode setting’ (red) will
quickly blink on the digital display, and the selected setting
will be confirmed.
The digital display will not blink (red) if the setting has not
been changed.
To Next Page
Loading...
