5-5. M.G.S. Function
The receiving light sensitivity can be set to one of four levels (Level 4 (Note) / Level 3 / Level 2 / Level 1).
Note: Level 4 can only be set in ultra long-range (U-LG) mode.
Level 4 (Note) Level 3 Level 2 Level 1
Press the
MODE key 5 times.
Turn the Jog switch once
toward the ‘
’ direction.
Turn the Jog switch
3 times toward
the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Select the desired sensitivity
by turning the Jog switch.
The digital display will quickly
blink to confirm the setting.
Press the
MODE key once.
Press the
MODE key once.
4Turn the [Jog switch] 3 times toward the ‘’ direction, to
enter the ‘M.G.S. (receiving light sensitivity) setting’ state.
5If the [Jog switch] is pressed, the current ‘receiving light
sensitivity’ (red) will be displayed.
* The factory setting is ‘level 3’.
* If the response time is changed, the maximum sensitivity
for the mode being set is set.
6If the [Jog switch] is turned, receiving light sensitivity (red)
will blink on the digital display.
Select the desired ‘receiving light sensitivity’ level.
* You can check the current incident light intensity at the
instant the jog switch is turned.
Products manufactured after July 2004 (Lot No.: 4G□~)
only.
7If the [Jog switch] is pressed, receiving light sensitivity (red)
will quickly blink on the digital display, confirming the
‘receiving light sensitivity’ level.
The digital display will not blink (red) if the setting has not
been changed.
3Press the [Jog switch] to enter the ‘response time change’
state.
2Turn the [Jog switch] once toward the ‘’ direction, to select
‘PRO1 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
8 If the [MODE key] is pressed once, the amplifier will return to
‘PRO1 mode’.
1Press the [MODE key] 5 times to select ‘PRO mode’.
To Next Page
Loading...
