6-2. Display Switching Function
In RUN mode, the digital display is fixed to either incident light intensity, % or peak hold / bottom hold display, but
you can select it to be a variable display.
* The factory setting is for ‘no digital display switching’.
Press the
MODE key 5 times.
Display
switching
No display
switching
Turn the Jog switch twice
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Select the desired display setting
by turning the Jog switch.
Press the
MODE key once.
Press the
MODE key once.
The digital display will quickly
blink to confirm the setting.
4If the [Jog switch] is pressed, the current ‘display switching
4If the [Jog switch] is pressed, the current ‘display switching
setting’ (red) will be displayed.
* The factory setting is ‘No display switching’.
5If the [Jog switch] is turned, display switching setting (red)
will blink on the digital display.
Select the desired ‘display switching setting’.
6If the [Jog switch] is pressed, display switching setting (red)
will quickly blink on the digital display, and the selected
‘display switching setting’ will be confirmed.
The digital display will not blink (red) if the setting has not
been changed.
3Press the [Jog switch] to enter the ‘display switching’ state.
2Turn the [Jog switch] twice toward the ‘’ direction, to
select ‘PRO2 mode’.
7If the [MODE key] is pressed once, the amplifier will return to
‘PRO2 mode’.
8Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
1Press the [MODE key] 5 times to select ‘PRO mode’.
To Next Page
Loading...
