Select the desired display setting
by turning the Jog switch.
6-5. Period Holding Function
This selects whether the peak hold value / bottom hold value during the hold ON period or the peak hold value /
bottom hold value within the digital display refresh period is displayed. When hold ON is set, holding starts from
the point when the peak / bottom display appears in RUN mode.
* Before using this function, set the display switching function to ‘Display switching’. (Refer to p. 32.)
Press the
MODE key 5 times.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
The digital display will quickly
blink to confirm the setting.
Press the
MODE key once.
Press the
MODE key once.
Turn the Jog switch twice
toward the ‘
Ⳮ’ direction.
Turn the Jog switch 3 times
toward the ‘
Ⳮ’ direction.
Period
holding OFF
Period
holding ON
5If the [Jog switch] is pressed, the current ‘period holding
setting’ (red) will be displayed.
* The factory setting is ‘period holding OFF’.
6If the [Jog switch] is turned, ‘period holding setting’ (red) will
blink on the digital display.
Select from either ‘period holding OFF’ or ‘period holding
ON’.
7If the [Jog switch] is pressed, period holding setting (red) will
quickly blink on the digital display, and the selected setting
will be confirmed.
The digital display will not blink (red) if the setting has not
been changed.
4Turn the [Jog switch] 3 times toward the ‘Ⳮ’ direction, to
enter the ‘period holding setting’ state.
3Press the [Jog switch] to enter the ‘display switching’ state.
2Turn the [Jog switch] twice toward the ‘Ⳮ’ direction, to
select ‘PRO2 mode’.
8If the [MODE key] is pressed once, the amplifier will return to
‘PRO2 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
1Press the [MODE key] 5 times to select ‘PRO mode’.
35
To Next Page
Loading...
