7-2. Data Bank Load Function
This function allows settings from the data bank to be selected and then loaded.
This feature allows settings to be changed quickly at times of reconfiguration, etc.
You can select whether the settings for only one amplifier are loaded or the settings for all amplifiers on the right
side that are connected via optical communication are loaded all in a single step.
Channel 1 Channel 3Channel 2
Press the
MODE key 5 times.
Turn the Jog switch 3 times
toward the ‘
Ⳮ’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Loading one
amplifier only
Loading all amplifiers
in a single step
Turn the Jog switch to select the
desired channel for loading.
Turn the Jog switch to select whether to load
settings for one amplifier or all amplifiers
in a single step.
Press the
MODE key
once.
Press the
MODE key
once.
The digital display will blink
to confirm the setting.
The digital
display will
blink to
confirm
the setting.
The digital display
will scroll twice.
* When loading only the
following one amplifier
* When loading all amplifiers
in a single step
1Press the [MODE key] 5 times to select ‘PRO mode’.
8
If the [Jog switch] is pressed, the letters ‘ ’ (red) will blink.
2Turn the [Jog switch] 3 times toward the ‘Ⳮ’ direction, to
select ‘PRO3 mode’.
3Press the [Jog switch] to enter the ‘data bank load setting’
state.
4If the [Jog switch] is pressed, the current setting will be
displayed.
5Turn the [Jog switch] to select whether to load settings for
one amplifier or all amplifiers in a single step.
6If the [Jog switch] is pressed, the selected setting will be
confirmed.
7If the [Jog switch] is turned, the ‘channel’ will be changed.
Select the desired ‘channel’ for loading.
0If the [MODE key] is pressed once, the amplifier will return to
‘PRO3 mode’.
APress the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
9If the [Jog switch] is pressed while ‘ ’ (red) is blinking, the
settings will be loaded from the selected ‘channel’. ‘ ’
(red) will quickly blink, and ‘ ’ (red) will blink to confirm
the new setting.
If loading settings for all amplifiers in a single step, the
display will scroll twice and then the channels being loaded
will blink (red) and the settings will be confirmed.
39
To Next Page
Loading...
