Panasonic LS-400 Series - External Input Switch Setting Function

8-4. External Input Switch Setting Function
Selects ‘emission halt’, ‘full-auto teaching’ or ‘limit teaching’ using external input wires.
* Equipped with cable type only.
The digital display will quickly
blink to confirm the setting.
Press the
MODE key 5 times.
Turn the Jog switch 4 times
toward the ‘
’ direction.
Turn the Jog switch twice
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Emission
halt
Full-auto
teaching
Limit
teaching
Plus side
Limit
teaching
Minus side
Press the
Jog switch.
Select mode
by turning the Jog switch.
Press the
MODE key once.
Press the
MODE key once.
1Press the [MODE key] 5 times to select ‘PRO mode’.
3Press the [Jog switch] to enter the ‘copy setting’ state.
2Turn the [Jog switch] 4 times toward the ‘’ direction, to
select ‘PRO4 mode’.
4Turn the [Jog switch] twice toward the ‘’ direction, to enter
the ‘external input switch setting’ state.
8If the [MODE key] is pressed once, the amplifier will return to
‘PRO4 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
5If the [Jog switch] is pressed, the current setting (red) will be
displayed.
* The factory setting is ‘emission halt’.
6If the [Jog switch] is turned, external input mode (red) will
blink on the digital display.
Select mode.
7If the [Jog switch] is pressed, external input mode (red) will
quickly blink on the digital display, confirming the mode.
The digital display will not blink (red) if the setting has not
been changed.
44
Ramco National
(800) 280-6933
www.panasonicsensors.com