Panasonic LS-400 Series - Backup Setting Function

8-5. Backup Function
This function is used for not storing the threshold value obtained from external input teaching into the EEPROM.
It prevents unnecessary writing to the EEPROM.
* Equipped with cable type only.
Backup
OFF
Backup
ON
Press the
MODE key 5 times.
Turn the Jog switch 4 times
toward the ‘
’ direction.
Turn the Jog switch 3 times
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Press the
MODE key once.
Press the
MODE key once.
The digital display will quickly
blink to confirm the setting.
Select from backup ON / backup OFF
by turning the Jog switch.
1Press the [MODE key] 5 times to select ‘PRO mode’.
3Press the [Jog switch] to enter the ‘copy setting’ state.
2Turn the [Jog switch] 4 times toward the ‘’ direction, to
select ‘PRO4 mode’.
4Turn the [Jog switch] 3 times toward the ‘’ direction, to
enter the ‘backup setting’ state.
8If the [MODE key] is pressed once, the amplifier will return to
‘PRO4 mode’.
9Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
5If the [Jog switch] is pressed, the current setting (red) will be
displayed.
* The factory setting is ‘Backup OFF’.
6If the [Jog switch] is turned, the setting (red) will blink on the
digital display.
Select from either ‘Backup ON’ or ‘Backup OFF’.
7If the [Jog switch] is pressed, the setting (red) will quickly
blink on the digital display, confirming ‘Backup ON / OFF’.
The digital display will not blink (red) if the setting has not
been changed.
45
Ramco National
(800) 280-6933
www.panasonicsensors.com