The input of a 8-digit code allows the configuration to be set directly, without the
need to set each individual function.
This function allows for automatic zeroing of the incident light intensity.
This function will cause all configuration settings to revert to factory settings.
However, any settings that have been saved within the data bank will not be
changed.
Please refer to the ‘3-2. Factory Settings’ on p. 4.
This selects one function that you would like to display in the navigation display in
CUSTOM mode.
Refer to p. 50 for setting procedure
Refer to p. 51 for setting procedure
Refer to p. 49 for setting procedure
Refer to p. 48 for setting procedure
:
0-Adjust Setting Function
:
Setting Reset Function
:
CUSTOM Mode Display Function
:
Code Setting Function
47
To Next Page
Loading...
