10. Using the Wi-Fi function
274
A picture can be automatically sent to a specified device every time you take it.
• When connected with [Send Images While Recording], [ ] is
displayed on the recording screen, and [ ] is displayed while
sending a file.
• To terminate the connection, follow the steps below:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]
• You can terminate the connection or change the send settings
by pressing [Wi-Fi]. (P261)
You cannot change the settings while sending pictures. Wait until sending is complete.
Images can be selected and sent after recording.
∫ How to select an image(s) after selecting [Single Select] or [Multi Select]
Send Images While Recording
• Since the camera gives priority to recording, sending may take longer during the recording.
• If you turn off this unit or the Wi-Fi connection before sending is complete, unsent pictures will
not be resent.
• You may not be able to delete files or use the playback menu while sending.
Not available in these cases:
• You cannot send motion pictures, 4K burst files and images recorded with the Post Focus
function.
Send Images Stored in the Camera
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
• The setting is cancelled when the picture is selected
again.
2 Select [OK].
• The number of pictures that can be sent by [Multi Select]
is limited.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
To Next Page
Loading...
