10. Using the Wi-Fi/NFC Function
256
What you can do with the [Wi-Fi] button when connected to Wi-Fi
•
Following items can be selected.
¢ This is not displayed when the destination of [Remote Shooting & View], [Playback on TV] or
[Send Images Stored in the Camera] is set to [Printer].
∫ Describing method
When “select [Select a destination from History]”, etc. is
described in a step, perform any of the following operations.
•
The camera cannot be used to connect to a public wireless LAN connection.
• Use a IEEE802.11b, IEEE802.11g or IEEE802.11n compatible device when using a wireless
access point.
• It is recommended to use a fully charged battery when sending images.
• When the battery indicator is flashing red, the connection with other equipment may not start or
the connection may be disrupted.
(A message such as [Communication error] is displayed.)
• When sending images on a mobile network, high packet communication fees may be incurred
depending on the details of your contract.
• Pictures may not be completely sent depending on radio wave conditions. If the connection is
terminated while sending pictures, pictures with missing sections may be sent.
• Do not remove the memory card or battery or move to an area without any reception
while sending images.
• The monitor display may become distorted for an instant while connected to the service,
however this will not affect the image being sent.
• If you use the HDMI output during recording with [Bit Mode] in [HDMI Rec Output] set to
[4:2:2 10bit], the Wi-Fi function will be disabled.
[Terminate the Connection] Terminates the Wi-Fi connection.
[Change the Destination]
Terminates the Wi-Fi connection, and allows you to
select a different Wi-Fi connection.
[Change Settings for Sending
Images]
¢
Refer to P301 for details.
[Register the Current Destination
to Favorite]
Registering the current connection destination or the
connection method, you can easily connect with the
same connection method next time.
[Network Address] Displays the MAC address and IP address of this unit.
Button operation: Select [Select a destination from
History] with the cursor button, and
then press [MENU/SET].
Touch operation: Touch [Select a destination from
History].
To Next Page
Loading...
Need help?
General
