106 VQT2R24 VQT2R24 107
For [REC] menu setting procedures (→20)
Using [REC]/[MOTION PICTURE] menu
(Continued)
[REC QUALITY]
Sets the picture quality of the motion picture that is recorded.
■
Recording mode: → [MOTION PICTURE] menu
■
Settings:
[AVCHD Lite (GPS)] in [REC MODE]
Setting Resolution Bit rate
∗
1
Aspect ratio
[GSH] 1280 x 720 17 Mbps
16:9[GH] 1280 x 720 13 Mbps
[GL] 1280 x 720 9 Mbps
[AVCHD Lite] in [REC MODE]
Setting Resolution Bit rate
∗
1
Aspect ratio
[SH] 1280 x 720 17 Mbps
16:9[H] 1280 x 720 13 Mbps
[L] 1280 x 720 9 Mbps
[MOTION JPEG] in [REC MODE]
Setting Resolution Frame rate
∗
2
Aspect ratio
[HD] 1280 x 720 30 fps
16:9
[WVGA] 848 x 480 30 fps
[VGA] 640 x 480 30 fps
4:3
[QVGA] 320 x 240 30 fps
∗
1
The bit rate is the amount of data per unit time. A higher value translates into a higher image
quality. This camera uses the VBR (Variable Bit Rate) recording system and the available
recording time is shorter when recording a subject with rapid movements.
∗
2
The frame rate is the number of frames per second.
●
[WVGA] cannot be set in [INTELLIGENT AUTO] Mode.
●
[QVGA] only can be recorded to the built-in memory.
[REC QUALITY]
For details (→77)
[CONTINUOUS AF]
Either allow the focus to be constantly adjusted during motion picture recording, or fix the
focus position at the start of recording.
■
Recording mode: → [MOTION PICTURE] menu
→ [REC] menu
■
Settings: [ON] : Adjust focus according to movement of subject during motion picture
recording. ( appears on the screen.)
[OFF] : Fix focus position at the start of motion picture recording.
Use this setting to keep the same focus position for subjects with
little forward/backward movement.
[WIND CUT] is not available in the DMC-TZ9/DMC-TZ8.
[WIND CUT]
Reduces recording of wind sounds (wind noise) when recording in a strong wind
■
Recording mode: → [MOTION PICTURE] menu
■
Settings: [OFF]/[ON] ( appears on the screen.)
●
When [WIND CUT] is set to [ON], lower sounds will be eliminated and the sound quality
will differ from that of normal recordings.