134 VQT2R24 VQT2R24 135
Using [PLAYBACK] menu (Continued)
Playback mode: (Set mode dial to any except )
For the [PLAYBACK] menu setting procedure (→20)
[COPY]
You can copy pictures between built-in memory and memory card.
Set-up: Press [MENU/SET] → [PLAYBACK] menu → Select [COPY]
Select copy method (direction)
: Copy all pictures from built-in memory to card
(go to step )
(Clipboard pictures cannot be copied. Use
[COPY] in the [CLIPBOARD] menu (→109).)
: Copy 1 picture at a time from card to built-in
memory.
: Copy 1 picture at a time from card to clipboard
folder (in built-in memory) (not motion pictures).
Select picture with ◄ ► and press [MENU/SET] (for and
)
Select [YES]
• To cancel → Press [MENU/SET]
• After confirmation, press to return to the menu
screen.
(Screen shown is example)
●
If there is not enough space on the built-in memory for copying to be performed, turn
off the power, remove the card, and delete pictures from the built-in memory (to delete
clipboard pictures, set the mode dial to Clipboard Mode).
●
Copying of picture data from the built-in memory to memory cards will be terminated
midway if there is insufficient space on the card. Using memory cards with higher
capacities than the built-in memory (approx. 15 MB , approx. 40 MB ) is
recommended.
●
Copying pictures may take several minutes. Do not turn off power or perform other
operations during copying.
●
If identical names (folder/file numbers) are present in the copy destination, a new
folder for copying will be created when copying from built-in memory to card ( ).
Identically-named files will not be copied from card to built-in memory ( ).
●
DPOF settings will not be copied.
●
Only pictures from Panasonic digital cameras (LUMIX) may be copied.
●
Original pictures will not be deleted after copying (to delete pictures (→45)).
●
This setting can only be made when the Playback Mode is [NORMAL PLAY].
●
Motion pictures recorded in [AVCHD Lite] format cannot be set.
[PLACE-NAME EDIT]
You can edit place name information recorded by GPS function.
Operation: Press [MENU/SET] on the playback screen and select →
[PLAYBACK] menu → [PLACE-NAME EDIT]
Select the picture
Select the location name or
landmark name to edit.
Select [REPLACE]
Enter characters (Entering text
(→111))
Select [YES]
If you want to edit another
location name or landmark
name, repeat steps to
• After setting, press to return to the
menu screen.
■
To delete a location name or landmark name
In step
, select [DELETE] with ▼, and then select [YES].
To Next Page
Loading...
